Finally, I've made possible to operate Alpy600 calibration module remotely from my computer, using the same controller module I am using to operate a focuser motor, as I told in another topic:
http://www.spectro-aras.com/forum/viewt ... =866#p3918
Link to controller and cable manufacturer/seller:
http://www.lunatico.es
http://tienda.lunatico.es
Seletek module has to output ports. On the first is attached cable to focuser motor. At the second port (EXP) is attached a two way connector which attaches to Alpy calibr. module connectors. At computer, from a program named pinbypin, I can switch ON and OFF pins number 2 and 3. Pin #2 is connected to flat lamp, and #3 is connected to neon lamp.
Alpy600 calibration module remote operation
-
- Posts: 36
- Joined: Sat May 31, 2014 4:52 pm
- Location: Madrid, Spain
Alpy600 calibration module remote operation
- Attachments
-
- Pin 2 is switched ON
- Pin-2_ON.JPG (28.05 KiB) Viewed 1798 times
-
- Calibration module lamps are switched off
- Pin-2_OFF.JPG (27.39 KiB) Viewed 1798 times